电话
联系我们
CONTACT US
传真:0531-86370030
邮箱:870027617@qq.com
地址:济南解放东路29号
知识专栏
您当前所在的位置:首页 - 新闻资讯 > 知识专栏 >
建造防腐木亭子的注意事项

来源:http://www.jnajgc.com 时间:2021-05-28

防腐木凉亭是用防腐木组建而成,防腐木是将木材经过特殊防腐处理后,具有防腐烂、防白蚁、防真 菌的功效。同时还能抑 制处理木材含水率的变化,减少木材开裂的程度。
The antiseptic wood Pavilion is made of antiseptic wood. Antiseptic wood has the functions of antiseptic, termite and fungus after special antiseptic treatment. At the same time, it can inhibit the change of moisture content of treated wood and reduce the degree of wood cracking.
能够直接接触土壤及潮湿环境,经常使用在户外地板,工程,景观,防腐木花架等,供人们歇息和欣赏自然美景,是户外地板、园林景观、木秋千,娱乐设施,木栈道等里理想材料。而防腐木凉亭也越来越走进人们的家庭,那建造时应该注意什么呢?
It can directly contact with soil and humid environment, and is often used in outdoor floor, engineering, landscape, antiseptic wooden flower rack, etc. for people to rest and enjoy natural beauty. It is an ideal material for outdoor floor, garden landscape, wooden swing, entertainment facilities, wooden plank road, etc. And antiseptic wood Pavilion is more and more into people's families, so what should be paid attention to when building?
1、所有的连接应使用镀锌连接件或不锈钢连接件及五金制品,以抗腐蚀,不能使用不同金属件,否则很快会生锈,使木制品结构受到根本损伤。
1. Galvanized or stainless steel connectors and hardware products shall be used for all connections to resist corrosion. Different metal parts shall not be used, otherwise it will rust quickly and cause fundamental damage to the wood structure.
2、在制作和穿孔的过程中,应先用电钻打眼,然后用螺丝等固定,以免造成 人为的开裂。
2. In the process of production and perforation, electric drill should be used to drill holes first, and then fixed with screws, so as to avoid artificial cracking.
3、待木材干燥或风干后在其表面上使用木材防护漆进行涂刷。使用户外木材专用漆时应注意首先要充分摇匀,涂饰后需24小时的晴天条件,使涂料在木材表面成膜。
3. After the wood is dried or air dried, the wood protective paint shall be applied on the surface. When using outdoor wood special paint, it should be noted that first of all, it should be fully shaken. After finishing, it needs 24 hours of sunny conditions to make the paint film on the surface of wood.
4、防腐木在运到施工现场时,应通风存放并尽可能的避免阳光暴晒直射。在防腐木木屋设计施工时,应尽可能全角和防腐木材料现有的尺寸如需切割、钻孔等,要使用防腐剂进行涂刷补救,以保证仿防腐层的完整性。在连接时应预孔,这样可以减少开裂。
4. When the anticorrosive wood is transported to the construction site, it should be stored in ventilation and avoid direct sunlight as far as possible. In the design and construction of the anti-corrosion wooden house, the full angle and the existing size of the anti-corrosion wood materials should be used as far as possible. If cutting, drilling, etc. are needed, preservatives should be used to brush and repair, so as to ensure the integrity of the anti-corrosion coating. Holes should be pre drilled during connection to reduce cracking.
5、搭建防腐木栈道、地板、露台时,尽量使用长木板,减少接头,以求美观,板面之间留5-10mm缝隙。亭子的所有连接点请使用镀锌紧固件,或不锈钢及五金,防止生锈而造成防腐剂流失。
5. When building anti-corrosion wood plank road, floor and terrace, try to use long boards to reduce joints, so as to be beautiful, and leave 5-10mm gap between the boards. Please use galvanized fasteners, stainless steel and hardware at all connection points of pavilion to prevent corrosion and corrosion.