电话
联系我们
CONTACT US
传真:0531-86370030
邮箱:870027617@qq.com
地址:济南解放东路29号
公司要闻
您当前所在的位置:首页 - 新闻资讯 > 公司要闻 >
j济南防腐木的三种安装方法

来源:http://www.jnajgc.com 时间:2021-09-17

1、活动铺设法:
1. Activities:
(1)用不锈钢十字螺丝在防腐木的正面与龙骨连接;
(1) Stainless steel cross screws are used to connect with the keel on the front of the anti-corrosion wood;
(2)用螺丝把龙骨固定在防腐木反面,几块组成拼成一个整体,既不破坏地面结构,也可自由拆卸清洗;
(2) The keel is fixed on the reverse side of the anti-corrosion wood with screws, and several pieces are assembled into a whole, which not only does not damage the ground structure, but also can be disassembled and cleaned freely;
2、固定铺设法:用膨胀螺丝把龙骨固定在地面上,膨胀镙丝应用尼龙材质的(抗老化比较好),铁膨胀管应涂刷防锈漆,然后再铺设防腐木.
2, fixed shop: try to use the expansion screws to fix the keel on the ground. The expanded yarn is made of nylon material (anti-aging is better). The iron expansion pipe should be painted with anti rust paint, and then lay up the rotten wood.
3、悬浮铺设法,龙骨在地面找平可连接成框架/井字架结构,然后再铺设防腐木.
3. Suspended paving, keel leveling on the ground can be connected into frame / well frame structure, and then anti-corrosion wood is paved
(1)木结构基层的处理:设计施工中应充分保持防腐木材与地面之间的空气流通,可以更有效延长木结构基层的寿命.
(1) Treatment of wood structure base course: air circulation between anti-corrosion wood and ground shall be fully maintained during design and construction, which can more effectively prolong the service life of wood structure base course
(2)制作安装防腐木时,防腐木之间需留0.2-1CM的缝隙(根据木材的含水率再决定缝隙大小,木材含水率超过30%时不应超过0.8CM为好)可避免雨天积水及防腐木的膨胀;
(2) When making and installing anti-corrosion wood, a gap of 0.2-1cm shall be left between the anti-corrosion wood (the gap size shall be determined according to the moisture content of wood, and it shall not exceed 0.8cm when the moisture content of wood exceeds 30%) to avoid ponding and expansion of anti-corrosion wood in rainy days;
(3)厚度大于50mm或者大于90mm的方柱为减少开裂可在背面中心位置开一道槽.
(3) For square columns with a thickness of more than 50mm or more than 90mm, a groove can be opened at the center of the back to reduce cracking
(4)五金件应用不锈钢、热镀锌或铜制的(主要避免日后生锈腐蚀,并影响连接牢度)连接安装时请预先钻孔,以避免防腐木开裂.
(4) The hardware shall be made of stainless steel, hot-dip galvanized or copper (mainly to avoid rust and corrosion in the future and affect the connection fastness). During installation, please drill holes in advance to avoid cracking of anti-corrosion wood
(5)尽可能使用现有尺寸及形状,加工破损部分应涂刷防腐剂和户外防护涂料;因防腐木本身是半成品,毛糙部分可在铺完后等木材含水率降到20%以下,再砂光一遍,如想有更好的效果,表面清理干净后亦可涂刷户外防护涂料(如有颜色的保护涂料应充分搅匀).如遇阴雨天,先用塑料布盖住,等天晴后再刷户外保护涂料.注:涂刷后24小时之内应避免雨水.
(5) The existing size and shape shall be used as much as possible, and the damaged parts shall be painted with preservatives and outdoor protective coatings; Since the anticorrosive wood itself is a semi-finished product, the rough part can be sanded again after the wood moisture content is reduced to less than 20%. If you want to have a better effect, you can also brush the outdoor protective coating after the surface is cleaned (if there is a colored protective coating, it should be fully mixed). In case of cloudy and rainy days, cover it with plastic cloth first, and then brush the outdoor protective coating after it is sunny. Note: rain should be avoided within 24 hours after painting
(6)表面用户外防护涂料或油基类涂料涂刷完后(只需一遍)为了达到好的效果,48小时内避免人员走动或重物移动,以免破坏防腐木面层已形成的保护膜.如想取得更优异的防脏效果,必要时面层再做两道专用户外清漆处理.
(6) After the surface is painted with outdoor protective coating or oil-based coating (only one time), in order to achieve good results, avoid moving people or heavy objects within 48 hours, so as not to damage the protective film formed on the anti-corrosion wood surface. If you want to achieve better anti dirt effect, the surface shall be treated with two layers of special outdoor varnish if necessary
(7)由于户外环境下使用的特殊性,防腐木会出现裂纹、细微变形、属正常现象,并不影响其防腐性能和结构强度.
(7) Due to the particularity of use in outdoor environment, the anti-corrosion wood will have cracks and slight deformation, which is normal and does not affect its anti-corrosion performance and structural strength
(8)一般户外木材防护涂料是渗透型的,在木材纤维会形成一层保护?膜,可以有效阻止水对木材的侵蚀,清洁可用一般洗涤剂来清洗,工具可用刷子.
(8) Generally, outdoor wood protective coatings are permeable. Will a layer of protection be formed in wood fibers? Membrane can effectively prevent water from eroding wood. General detergent can be used for cleaning, and brush can be used for tools
(9)1年至1.5年左右做一次维护;用专用的木材水性涂料或油性涂料涂刷即可.
(9) Maintain once every 1 to 1.5 years; It can be brushed with special wood waterborne paint or oily paint