电话
联系我们
CONTACT US
传真:0531-86370030
邮箱:870027617@qq.com
地址:济南解放东路29号
公司要闻
您当前所在的位置:首页 - 新闻资讯 > 公司要闻 >
济南防腐木的安装方法是什么?

来源:http://www.jnajgc.com 时间:2020-08-05

 1. 可移动的铺设方法:
  1. Movable laying method:
  (1)防腐木正面与龙骨采用不锈钢十字螺丝连接;
  (1) the anti-corrosion wood front and keel are connected with stainless steel cross screws;
  (2)将龙骨用螺丝固定在防腐木上,将几块复合在一起成为一个整体,既不损坏地上的结构,又可自由拆卸和清洗;
  (2) fix the keel on the anti-corrosion wood with screws, and combine several pieces to form a whole, which will not damage the structure on the ground, but also can be disassembled and cleaned freely;
  2、固定敷设方法:膨胀螺丝将龙骨固定在地面上,膨胀螺丝采用尼龙材料(抗老化性较好),铁膨胀管应涂防锈漆,再铺防腐木。
  2, fixed installation method: expansion screws fixed the keel on the ground, the expansion screw was nylon material (anti-aging better), the iron expansion pipe should be painted with anti rust paint, and then covered with antiseptic wood.
  3、吊架敷设方法,龙骨在地面找平后可连接成框架/框架结构,再铺设防腐木。
  3. Hanger laying method: after the keel is leveled on the ground, it can be connected into a frame / frame structure, and then anti-corrosion wood is laid.
  (1)木结构基层处理:在规划和施工中应充分坚持防腐木与地面之间的空气循环,这样更有利于延长木结构基层的使用寿命。
  (1) base treatment of wood structure: the air circulation between anti-corrosion wood and the ground shall be fully adhered to in the planning and construction, so as to extend the service life of the base of wood structure.
  (2)防腐木在制作过程中,防腐木之间应留有0.2-1cm的间隙(间隙大小根据木材含水率确定;当木材含水率超过30%时,最好不超过0.8cm),以防止雨天积水和防腐木材膨胀;
  (2) in the process of making anticorrosive wood, a gap of 0.2-1cm shall be left between the anticorrosive wood (the gap size shall be determined according to the moisture content of the wood; when the moisture content of the wood exceeds 30%, it is better not to exceed 0.8cm), so as to prevent water accumulation in rainy days and expansion of the anticorrosive wood;
  (3)厚度大于50mm或大于90mm的方柱可在反中心开槽,以减少开裂。
  (3) square columns with thickness greater than 50mm or 90mm can be slotted in the reverse center to reduce cracking.
  (4)五金件采用不锈钢、热浸镀锌或铜(为防止锈蚀,应先连接,并影响连接牢度)连接装置,请提前钻孔,以防锈蚀木材开裂。
  (4) the hardware shall be connected by stainless steel, hot-dip galvanizing or copper (to prevent corrosion, it shall be connected first and affect the connection fastness). Please drill in advance to prevent the wood from cracking.
  (5)尽量使用现有的尺度和外形,对损坏部位使用防腐剂和现场防护漆;后防腐木材本身是一个半成品,粗糙的部分可以在商店里,如木材含水率低于20%,砂光,如果你想有一个更好的效果,可以涂完清洁外观领域保护涂层(如颜色保护涂层应该精力充沛的搅拌)。如遇下雨天,最好使用塑料布覆盖,如重新刷过田间防护漆后天气晴朗。注意:涂层应在雨后24小时内预防。
山东防腐木
  (5) try to use the existing size and shape, and apply preservative and on-site protective paint to the damaged parts; the post anticorrosive wood itself is a semi-finished product, the rough part can be in the shop, such as the moisture content of wood is less than 20%, sanding, if you want to have a better effect, you can finish the protective coating in the field of clean appearance (such as the color protective coating should be vigorously stirred). In case of rain, it is better to cover with plastic cloth, for example, it will be sunny after the field protective paint is repainted. Note: the coating should be prevented within 24 hours after rain.
  (6)表面涂上后现场保护涂层或油性涂料(只有一次),以达到最好的效果,在48小时内,以防止人员步行或搬重物,避免损伤防腐木材表面形成的保护膜层。如果想要获得更好的防污效果,需要对表层进行两次特殊的现场清漆处理。
  (6) after the surface is coated, the on-site protective coating or oily coating (only once) shall be applied to achieve the best effect. Within 48 hours, it is necessary to prevent people from walking or lifting heavy objects, and avoid damaging the protective film formed on the surface of anticorrosive wood. If you want to get better antifouling effect, you need to carry out two special field varnish treatments on the surface.
  (7)由于防腐木材在野外使用环境中的特殊性,防腐木材会出现裂缝、细微变形和正常现象,不影响其防腐性能和结构强度。
  (7) due to the particularity of antiseptic wood in the field, the antiseptic wood will have cracks, slight deformation and normal phenomenon, which will not affect its antiseptic performance and structural strength.
  (8)一般现场木材防护涂层是透水性的,在木材纤维中会构成一层防护吗?膜,可有效防止木材被水腐蚀,清洗时可用一般清洁剂清洗,东西可用刷子刷。
  (8) generally, the wood protective coating on site is water permeable. Will it form a protective layer in the wood fiber? The film can effectively prevent the wood from being corroded by water. When cleaning, it can be cleaned with general detergent, and things can be brushed with brush.
  (9)一年一次至一年半保护;使用特殊的木器水性涂料或油性涂料涂刷即可。
  (9) once a year to one and a half years protection; use special wood water-based coating or oil-based coating to brush.